7/25/2023 0 Comments Lepton 2.5![]() ![]() Input Supply Voltage: 2.8 V, 1.2 V, 2.5 V to 3. The FLIR Lepton 2.5 - Thermal Imaging Module is a radiometric-capable long wave infrared (LWIR) camera solution that is smaller than a dime, fits.Sensor Technology: Uncooled VOx microbolometer.Non-Uniformity Correction (NUC): Automatic with shutter W branching ratio is 1/9 per lepton and 3/9 per (colored) quark generation, leading to the.Image Optimization: Factory configured and fully automated.Array format: 80 × 60, progressive scan.Optimum Temperature Range: -10☌ to +80☌.Non-Operating Temperature Range: -40 ☌ to +80 ☌.Mechanical Interface: 32–pin socket interface to standard Molex® socket.Control Port: CCI (I2C-like), CMOS IO Voltage Levels.Output image independent of camera temperature. Spectral Range: Longwave infrared, 8 µm to 14 µm.Critical Specifications (Lepton 2. Scene Dynamic Range: -10-140 ☌ (high gain) up to 450☌ (low gain) typical The Lepton 2.5 is the only radiometric Lepton core available at this time.The radiometric design of this camera module captures accurate, calibrated, and noncontact temperature data in every pixel of each image for greater utilization in commercial applications. Radiometric Accuracy: High gain: Greater of +/- 5☌ or 5% (typical) Low gain: Greater of +/- 10☌ or 10% (typical) Teledyne FLIR Lepton 2.5 LWIR Micro Thermal Camera Module offers a focal plane array of 80 x 60 active pixels, 17m pixel size, and Output Format: User-selectable 14-bit, 8-bit (AGC applied), or 24-bit RGB (AGC and colorization applied). ![]() Input Clock: 25-MHz nominal, CMOS IO Voltage Levels.Effective Frame Rate: 8.6 Hz (commercial application exportable).The advanced very high resolution radiometer (AVHRR) debuted on TIROS-N in 1978, and then followed on NOAA 6. (VHRR), which flew on the NOAA 2-5 satellites commencing in 1972. Since when I used uvc-radiomatry.py with Y16 capture mode, the data only return me 8 bit long for each pixel. Relevant specifications of Lepton 2.5 can be found in Table 12.5 (FLIR, 2014). I believe that it does not support radiometric yet. The Flir Lepton thermal imaging modules are used in a vast array of commercial and industrial applications, such as Mobile Phones, Gesture Recognition, Building Automation, Thermal Imaging and Night Vision. Just curious, what is the minimum firmware version of PT1 that can get radiometric data from lepton 2.5. The radiometric Lepton captures accurate, calibrated, and non-contact temperature data in every pixel. FLIR Lepton 2.5 Thermal Imaging Camera IP68&IP69K MIL-STD-810H Glove Mode 8380mAh Battery w/ 33w Fast Charge. With a focal plane array of 80圆0 active pixels, this Lepton easily integrates into native mobile-devices and other electronics as an IR sensor or thermal image sensor. The FLIR Lepton® 2.5 Thermal Imaging Module is a radiometric-capable long-wave infrared (LWIR) camera solution that is small enough to fit inside a smartphone and is less expensive than traditional IR cameras. ![]()
0 Comments
Leave a Reply. |